Welcome Guest ( Log In)

 
 Reply to this topicStart new topic

Outline · [ Standard ] · Linear+

> AutoSelect all edges

Robert Andersson
post Jul 24 2012, 07:42 AM
Post #1


I-Beam
*******

Group: Channel Partners
Posts: 1,380
Joined: 17-October 01
Member No.: 43
-select a edge so it highlights in green.
-Hit TAB on the keyboard.
Ironcad now selects edges "all way around".

It have to be smooth corners to work.



Attached thumbnail(s)
Attached Image Attached Image
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
cborer
post Jul 24 2012, 09:43 AM
Post #2


TriBall
********

Group: Community Members
Posts: 1,611
Joined: 24-October 01
From: Switzerland
Member No.: 203
Cool!
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
cborer
post Jul 24 2012, 09:56 AM
Post #3


TriBall
********

Group: Community Members
Posts: 1,611
Joined: 24-October 01
From: Switzerland
Member No.: 203
Does not work here!
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
ysinitsyn
post Jul 24 2012, 10:24 AM
Post #4


Sphere
****

Group: Channel Partners
Posts: 325
Joined: 18-March 10
From: Ekaterinburg, Russia
Member No.: 49,708
I love it! Thanks
QUOTE(cborer @ Jul 24 2012, 09:56 AM)
Does not work here!
*


The edges mus be Smooth Connected
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
swallis
post Aug 16 2012, 12:21 PM
Post #5


Cylinder
**

Group: Community Members
Posts: 90
Joined: 3-December 07
Member No.: 35,056
The only way that tip could be better is if you had told me MUCH sooner. smile.gif
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
Cary OConnor
post Aug 16 2012, 03:18 PM
Post #6


TriBall
********

Group: IronCAD Employees
Posts: 5,627
Joined: 23-August 04
Member No.: 17
In 2013, there is a new selection tool coming out but it is only implemented in special commands like Patch Surface. For example: You can pick an edge and a face, and it will collect all the other edges in the loop that reside on the face even if it is not smooth connected.

Do you think this commad is more general and should be exposed in other areas?

Cary
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
dprodanic
post Aug 16 2012, 04:18 PM
Post #7


Sphere
****

Group: Channel Partners
Posts: 313
Joined: 6-May 11
From: Belgrade, Serbia
Member No.: 56,092
I`m waiting for this for a long time: simple doubleclick on edge for loop selection on view oriented face (primary face), then another doubleclick for loop on `secondary` face...
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 

Reply to this topicTopic OptionsStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
 

All content copyright IronCAD 2000-2008 Low-Bandwidth View Time is now: 19th June 2013 - 04:46 AM