Welcome Guest ( Log In)

 
Reply to this topicStart new topic

Outline · [ Standard ] · Linear+

> Double Click 3D Curves

tlehnhaeuser
post Aug 9 2010, 08:56 AM
Post #1


TriBall
********

Group: Channel Partners
Posts: 6,161
Joined: 17-October 01
From: Commack, New York
Member No.: 48



If you double click on 3D Curves this will bring you directly into edit mode.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
cborer
post Aug 10 2010, 03:43 AM
Post #2


TriBall
********

Group: Expired
Posts: 1,679
Joined: 24-October 01
From: Switzerland
Member No.: 203



Tom!
Welcome to Iron CAD
biggrin.gif
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
tlehnhaeuser
post Aug 10 2010, 08:19 AM
Post #3


TriBall
********

Group: Channel Partners
Posts: 6,161
Joined: 17-October 01
From: Commack, New York
Member No.: 48



laugh.gif
You never know, never know, never know, did I say never know?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
IronKevin
post Aug 10 2010, 09:26 AM
Post #4


TriBall
********

Group: IronCAD Employees
Posts: 18,653
Joined: 21-November 06
Member No.: 27,213



Any tips are good tips, beginners read these too!
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
dhovatter
post Aug 11 2010, 06:40 AM
Post #5


Sphere
****

Group: Community Members
Posts: 334
Joined: 24-October 01
From: Suwanee Geogia
Member No.: 131



IC Guys
Why not start a thread called "Did You Know" where as often as each day IC guys would post a little thing about some commands or procedures that would help. Even the other Old time users could add their wisdom.
The "IC Help Command" is sort of an joke in IC, not enough real how to information and on some things totaly non existent.
It could even be referenced to in later threads.
Or you could totaly revise the help command to have real information.
Dallas
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
cborer
post Aug 13 2010, 06:24 AM
Post #6


TriBall
********

Group: Expired
Posts: 1,679
Joined: 24-October 01
From: Switzerland
Member No.: 203



Yes I agree The Help menue did not often help me.
Could be advanced.

So thanks again to Tom!
...I was just kidding.

This post has been edited by cborer: Aug 13 2010, 06:25 AM
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicTopic OptionsStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
 

All content copyright IronCAD 2000-2008 Low-Bandwidth View Time is now: 19th December 2014 - 07:04 PM