Sometimes it may be neccesary to reorient hove IC looks at a part, when creating 2D views.
IC just looks in a straight angle in to whatever is in the scene.
This anim shows hove to handle this issue.

Note 1 "Coordinate System" have the label "Datum plane" in IronCAD 8.2 and older.

Note 2 If this assembly is inserted (used) in a another scene, it will KEEP its orientation in that scene. Still its good to check that thats the case until you are familiar with it.
If you turn/ move the parts inside a assembly, it will of course reorient where used also.

You can use this technigue OR you can place the camera as you like in the scene and then refer to that camera when placing the views in the drawing (From scene in the view creation dialog).

This post has been edited by Robert Andersson: Jun 15 2006, 09:52 AM

Attached thumbnail(s)