Any Ideas would be great on this one.

I've come up with a work around so that I can create a drawing at 1:1 in IC, I have created some scenes with a rectangles in each drawn to the size that will scale down in a standard drawing to fill up to the template border. These are 2D sketches in the scene.
eg. scene rectangle 6000mm x 4155mm when dropped at 1:15 fits inside the border of an A3 sheet, I can then edit the view at 1:1.

The problem is that the orientation of the rectangle is not visible in the preview of the scene in the projection dialogue, I have to drop in the front view, exit then if the rectangle is side on, I have to go back and click up/down/sideways and try again.
Is there a way if making the sketch visible?
And is it possible to drop the view so that is centered to the page?

Hey Eric I've had the same problem of over use of Esc during a edit view and losing all the curves in the session, Bummer!

regards