Welcome Guest ( Log In)

 
Reply to this topicStart new topic

Outline · [ Standard ] · Linear+

> Editing the Animation Spin Value

Cary OConnor
post Jul 9 2010, 04:13 PM
Post #1


TriBall
********

Group: IronCAD Employees
Posts: 5,928
Joined: 23-August 04
Member No.: 17



When working with animations, there is a way to edit the spin animation value after it is applied (I always thought I had to delete and recreate). Go to the SmartMotions editor and find the path for the spin. Right-click on it and edit the properties. Click on the "Path" tab. Select the up arrow on the Current Key setting to get to #2. Select Key Setup. In the drop-down, select to "Pan". The value of the spin is listed here.

Yes this is a few clicks, but if you have a complicated path that is already setup for a time sequence, this is easier to edit than to recreate in some cases.

Enjoy,
Cary
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
Robert Andersson
post Jul 9 2010, 05:48 PM
Post #2


I-Beam
*******

Group: Channel Partners
Posts: 1,430
Joined: 17-October 01
Member No.: 43



I had known this for YEARS, haha
This is one of the most buried commands in IC.
How about a handle for this one?


This post has been edited by Robert Andersson: Jul 9 2010, 05:58 PM
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Reply to this topicTopic OptionsStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
 

All content copyright IronCAD 2000-2008 Low-Bandwidth View Time is now: 22nd September 2014 - 10:11 AM