Welcome Guest ( Log In)

 
 Reply to this topicStart new topicStart Poll

Outline · [ Standard ] · Linear+

> Constraining Attachment Ponts?

tlehnhaeuser
post Jan 7 2011, 04:09 PM
Post #1


TriBall
********

Group: Channel Partners
Posts: 5,702
Joined: 17-October 01
From: Commack, New York
Member No.: 48
Does anyone know if theres a way to constrain an attachment points location to a part that uses Design Variations?

When I chnage the DV that attachment point does not "stick" to the point where I created it.

I welcome any thoughts
Tom
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
tlehnhaeuser
post Jan 7 2011, 04:14 PM
Post #2


TriBall
********

Group: Channel Partners
Posts: 5,702
Joined: 17-October 01
From: Commack, New York
Member No.: 48
NEVER MIND I FIGURED OUT, SORRY
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
Cary OConnor
post Jan 7 2011, 04:23 PM
Post #3


TriBall
********

Group: IronCAD Employees
Posts: 5,627
Joined: 23-August 04
Member No.: 17
Just so everyone knows, you have to use the Face Lock.

Cary
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
swallis
post Jan 7 2011, 07:09 PM
Post #4


Cylinder
**

Group: Community Members
Posts: 90
Joined: 3-December 07
Member No.: 35,056
QUOTE(Cary OConnor @ Jan 7 2011, 03:23 PM)
Just so everyone knows, you have to use the Face Lock.

Cary
*


But what if we don't like that social networking stuff... dry.gif
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
tlehnhaeuser
post Jan 10 2011, 10:28 AM
Post #5


TriBall
********

Group: Channel Partners
Posts: 5,702
Joined: 17-October 01
From: Commack, New York
Member No.: 48
QUOTE(swallis @ Jan 7 2011, 06:09 PM)
But what if we don't like that social networking stuff...    dry.gif
*



tongue.gif You better like it, your job may depend on it.
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 

Reply to this topicTopic OptionsStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
 

All content copyright IronCAD 2000-2008 Low-Bandwidth View Time is now: 20th June 2013 - 03:15 AM