Welcome Guest ( Log In)

Reply to this topicStart new topic

Outline · [ Standard ] · Linear+

> How to do pattern on a pattern.

post Feb 17 2011, 05:13 AM
Post #1


Hi All,
I just found it but don't know if it is safe.
Firstly, use triball to pattern a part. Then we can not do pattern on the pattern because the menu item is gray.
Attached Image
Then put the patten into an assembly, I can do pattern on the assembly!


This post has been edited by xxu: Feb 17 2011, 05:16 AM
Go to the top of the page
+Quote Post

Reply to this topicTopic OptionsStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

All content copyright IronCAD 2000-2008 Low-Bandwidth View Time is now: 29th September 2016 - 09:31 PM