Welcome Guest ( Log In)

 
 Reply to this topicStart new topic

Outline · [ Standard ] · Linear+

> Troubleshooting Bad Models

tlehnhaeuser
post May 13 2011, 01:37 PM
Post #1


TriBall
********

Group: Channel Partners
Posts: 5,689
Joined: 17-October 01
From: Commack, New York
Member No.: 48
First Kudos to IronDudes!
Not sure when this ability appeared but glad I found it.

If you run a Statistics check on your model and it has bad entitities, they will be indicated by yellow dots. Not to mention if you select the issue from the dialog it will highlight the associated problems with dots. Also you can manipulate your view while the dialog box is still open.

GREAT JOB!

Tom
Attached Image
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
David Thomas
post Jun 2 2011, 06:16 AM
Post #2


Sphere
****

Group: Expired
Posts: 273
Joined: 25-July 03
From: UK South West
Member No.: 1,408
its present in v10 as I came across this for the first time just the other day. It was handy , my fix was to switch the part to parasolid and back again to acis and it seemed to fix it. (Nasty ProE geometry)
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 

Reply to this topicTopic OptionsStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
 

All content copyright IronCAD 2000-2008 Low-Bandwidth View Time is now: 22nd May 2013 - 01:28 AM