Outline · [ Standard ] · Linear+ A Part Parasolid cannot make

[tlehnhaeuser]

Apparently when I swithc this part from Acis to Parasolid cannopt make it ;-)

Also I cannot shell this part. Not sure why.

If anyone wants to try.

FYI Created in IC 2012.2

tom
 Sound_Tube.ics ( 103.5k ) Number of downloads: 86

[dprodanic]

Solution:


Do not ask way.....


This post has been edited by dprodanic: Jun 20 2012, 02:45 PM

[tlehnhaeuser]

Hmmm interesting. thanks D PRO or should I say IC PRO ;-)

[bmodi]

Hi Tom

please see attached, the vertical line was not 90 deg!!
thx
Bimal

Apparently when I swithc this part from Acis to Parasolid cannopt make it ;-)

Also I cannot shell this part. Not sure why.

If anyone wants to try.

FYI Created in IC 2012.2

tom
 Sound_Tube.ics ( 103.5k ) Number of downloads: 86

Attached thumbnail(s)

[Mike Allen]

It's possible that this might be a more extensive issue. I thought it might have been my imagination, but it seems more common lately to have extremely small imprecisions crop up - 99.99998, instead of 100, for example. I haven't had time to document it, however. It seems to happen mostly when sketching (I think.)

[tlehnhaeuser]

Thanks Bimal, nice catch.
And Mike, I get this issue everytime typically when rotating decals, etc... i.e. 90 degrees is 90.00003 degrees