If you double click on 3D Curves this will bring you directly into edit mode.

Tom!
Welcome to Iron CAD

You never know, never know, never know, did I say never know?

Any tips are good tips, beginners read these too!

IC Guys
Why not start a thread called "Did You Know" where as often as each day IC guys would post a little thing about some commands or procedures that would help. Even the other Old time users could add their wisdom.
The "IC Help Command" is sort of an joke in IC, not enough real how to information and on some things totaly non existent.
It could even be referenced to in later threads.
Or you could totaly revise the help command to have real information.
Dallas

Yes I agree The Help menue did not often help me.
Could be advanced.

So thanks again to Tom!
...I was just kidding.