Help - Search - Member List - Calendar
Full Version: Edge Pattern?
IronCAD Community > Discussion Forums > General Discussion
tlehnhaeuser
Apr 14 2011, 11:01 AM
Not sure if I'm doing something wrong, but I cannot get the edge pattern laid out properly
I welcome any feedback.

I have attached video and scene file

tom

[attachmentid=6127]
IronKevin
Apr 14 2011, 11:27 AM
Those settings should work, must be something specific about the part, can you send it?
tlehnhaeuser
Apr 14 2011, 01:11 PM
QUOTE(IronKevin @ Apr 14 2011, 10:27 AM)
Those settings should work, must be something specific about the part, can you send it?
*


the part should is in that original .7z file called "Boot.ics"
thanks
tom
Cary OConnor
Apr 14 2011, 03:03 PM
The edge is not planar. The Edge pattern is limited to planar edges in order to determine the offset direction and to avoid twist.

Cary
tlehnhaeuser
Apr 15 2011, 09:34 AM
QUOTE(Cary OConnor @ Apr 14 2011, 02:03 PM)
The edge is not planar. The Edge pattern is limited to planar edges in order to determine the offset direction and to avoid twist.

Cary
*



Aha Light Bulb moment excl.gif
Cary OConnor
Apr 15 2011, 10:00 AM
by the way, it should pop up a message stating this. If you toggle the offset check-box it pops up on my machine.

Cary
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.